Skip to content
T&S Brass B-0230-KIT Inlet Kit 24 Inch Flex Supply Hoses
T&S B-0230-KIT Inlet Kit 1/2 NPT Nipples Elbows 24" Flex Hoses
The T&S Brass B-0230-KIT gives you everything needed to connect supply-side plumbing on a T&S B-0230 series wall-mount mixing faucet in one code-compliant kit. It covers the full run from the wall stub-out to the faucet body — brass fittings, lock hardware, and 24" stainless steel flex supply hoses included. Plumbers and foodservice technicians reach for this kit when installing new faucets or replacing worn inlet hardware without sourcing parts separately.
- Includes two short brass elbows with 1/2" MNPT, four 1/2" NPT supply nipples, two locknuts with washers, and two 24" flexible stainless steel supply hoses
- Hose inlets are 3/8" compression; fittings connect at 1/2" NPT — sized to match B-0230 series wall-mount mixing faucets with 1/2" NPT female inlets
- Certified to ASME A112.18.1/CSA B125.1, NSF 61-Section 9, and NSF 372 — meets code requirements for commercial foodservice plumbing connections
- Brass construction on fittings and nipples; stainless steel flex hoses resist corrosion in wet kitchen environments
- Consolidates the parts most often needed for a clean, code-compliant wall-mount faucet rough-in into a single part number
A good fit for restaurant builds, kitchen remodels, or service calls where the existing inlet hardware is corroded or damaged and the full connection needs to be replaced at once.
Specifications
| Hose Material | Stainless Steel (flexible) |
|---|---|
| Fitting Material | Brass |
| Nipple/Elbow Connection Size | 1/2 in NPT |
| Hose Inlet Connection | 3/8 in Compression |
| Kit Contents | 2 short elbows (1/2 in MNPT), 4 supply nipples (1/2 in NPT), 2 locknuts, 2 washers, 2 flexible stainless steel supply hoses (24 in) |
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm.
For more information, visit
www.P65Warnings.ca.gov.
